The 6ft Rubber Parking Block with Black and Yellow Stripes is the ultimate solution for effective parking management. Made from durable, eco-friendly materials, this parking block is designed to withstand harsh weather and impacts while maintaining its shape and functionality. Its high-contrast black and yellow striped design enhances visibility, making it perfect for parking lots, garages, and driveways.
Includes:
(1) 6ft Rubber Parking Block with Black and Yellow Stripes Kit
Features:
- Made from durable recycled rubber, resistant to chipping, cracking, or crumbling.
- Weatherproof, and resistant to oil, salt, and moisture.
- Features yellow reflective stripes for improved visibility.
- UV protection to resist damage from prolonged sun exposure.
- Made in the U.S.A.
Specifications:
-
Material: Recycled rubber
-
Color: Black with yellow reflective stripes
-
Holes: 4 holes, each 0.75" deep
-
Signs: Easily slide in and out
-
Dimensions: 72” L x 6” W x 4.5” H
-
Weight: 36 lbs.
Asphalt Installation Instructions:
-
Drill Pilot Holes: Start by drilling pilot holes through the asphalt using a 1/2" diameter drill bit. Ensure the holes are 3" deep.
-
Clean the Area: Thoroughly clean the area where the installation will occur to ensure a secure and stable installation.
-
Position the Product: Place the product in the desired location, ensuring it is properly aligned.
-
Install Washers: Secure the product by placing the washers in position.
-
Drive the Spikes: Begin driving the spikes into the asphalt but avoid fully setting any of them until all spikes are in place.
-
Use Adhesive (if applicable): For installations where no hardware is allowed, apply 10 ounces of epoxy or construction adhesive (e.g., Polyurethane PL Premium) to secure the product.
Concrete Installation Instructions:
-
Drill Holes: Drill three 3/4" holes, 2" deep. Insert the shield with the threaded end facing inward. For optimal expansion, ensure that the shield slightly protrudes above the concrete surface before setting.
-
Prepare the Area: Thoroughly clean the installation area to ensure proper adhesion and fit.
-
Position the Product: Place the product in the desired position.
-
Install Washers: Position the washers as needed.
-
Apply Adhesive: Apply a bead of adhesive along the leading edges of the Speed Humps and End Caps.
-
Insert Lag Screws: Insert the lag screws, starting all screws before tightening any. Tighten each screw using a wrench until firm resistance is felt.
-
Use Adhesive (If Necessary): For installations where hardware is not allowed, use 10 ounces of epoxy or construction adhesive (e.g., Polyurethane PL Premium) to secure the product.
Resources: