The 6ft Rubber Parking Block with Black and Yellow Stripes is the ultimate solution for effective parking management. Made from durable, eco-friendly materials, this parking block is designed to withstand harsh weather and impacts while maintaining its shape and functionality. Its high-contrast black and yellow striped design enhances visibility, making it perfect for parking lots, garages, and driveways.

Includes:
(1) 6ft Rubber Parking Block with Black and Yellow Stripes Kit

Features:

Made from durable recycled rubber, resistant to chipping, cracking, or crumbling.
Weatherproof, and resistant to oil, salt, and moisture.
Features yellow reflective stripes for improved visibility.
UV protection to resist damage from prolonged sun exposure.
Made in the U.S.A.

Specifications:

Material: Recycled rubber
Color: Black with yellow reflective stripes
Holes: 4 holes, each 0.75" deep
Signs: Easily slide in and out
Dimensions: 72” L x 6” W x 4.5” H
Weight: 36 lbs.

Asphalt Installation Instructions:

Drill Pilot Holes: Start by drilling pilot holes through the asphalt using a 1/2" diameter drill bit. Ensure the holes are 3" deep.
Clean the Area: Thoroughly clean the area where the installation will occur to ensure a secure and stable installation.
Position the Product: Place the product in the desired location, ensuring it is properly aligned.
Install Washers: Secure the product by placing the washers in position.
Drive the Spikes: Begin driving the spikes into the asphalt but avoid fully setting any of them until all spikes are in place.
Use Adhesive (if applicable): For installations where no hardware is allowed, apply 10 ounces of epoxy or construction adhesive (e.g., Polyurethane PL Premium) to secure the product.

Concrete Installation Instructions:

Drill Holes: Drill three 3/4" holes, 2" deep. Insert the shield with the threaded end facing inward. For optimal expansion, ensure that the shield slightly protrudes above the concrete surface before setting.
Prepare the Area: Thoroughly clean the installation area to ensure proper adhesion and fit.
Position the Product: Place the product in the desired position.
Install Washers: Position the washers as needed.
Apply Adhesive: Apply a bead of adhesive along the leading edges of the Speed Humps and End Caps.
Insert Lag Screws: Insert the lag screws, starting all screws before tightening any. Tighten each screw using a wrench until firm resistance is felt.
Use Adhesive (If Necessary): For installations where hardware is not allowed, use 10 ounces of epoxy or construction adhesive (e.g., Polyurethane PL Premium) to secure the product.

Resources:

6ft Rubber Parking Block Specification Sheet

Parking Lot Safety

Filter products